Datapath VSN450 - Manual (Page 9)

9
Onboard Graphics Adaptor Disabled
If you do not require a control screen, then you should disable the integrated graphics as described below.
Connect a monitor to the onboard graphics device output and enter setup from the boot screen by
pressing <DEL> as prompted.
In the BIOS setup utility select:
Advanced Mode>System Agent Configuration>Graphics Configuration>Primary Display [PCIE]
If the onboard graphics is disabled, a PCIe graphics device should be installed in slot 1 on the
motherboard, slot 1 is located nearest to the CPU.
Use of the Onboard Graphics Adaptor
Onboard Graphics Adaptor used as Control Screen
The VSN450 is shipped with the BIOS configured to boot off the onboard graphics device. This output can
then be used as the control screen for a typical wall configuration.
To set the system to boot on the onboard graphics device (“Internal Graphics Processing Unit” - IGPU),
enter setup from the boot screen by pressing <DEL> as prompted.
In the BIOS setup utility select:
Advanced Mode>System Agent Configuration>Graphics Configuration>Primary Display [IGPU]
Fig.6