Dorcy 41-1088 User Manual

5 million candle power spotlight

Advertising
background image



IMPORTANT

SAFETY

INSTRUCTIONS

NEVER touch the lens while

in use. Danger of high heat at

the lens surface.

Light of halogen spotlight is

very bright, so NEVER look

directly into light or shine into

someone’s eye.

NEVER touch the halogen

lamp with bare hands (natural

oil from hand could damage

the bulb).

NEVER use the spotlight in

water or close to fire.

NEVER leave the spotlight

unattended during use, and

always KEEP AWAY FROM

CHILDREN.

ONLY use the accompanied

AC power supply OR the 12V

DC car plug to recharge the

spotlight.

NEVER USE SPOTLIGHT

WHILE PLUGGED IN AND

BEING CHARGED.

BEFORE USE:

Please read the following instructions carefully
in order to avoid any functional disorders or
damages.

CHARGE BATTERY 20 hours using

AC charger or 12 hours using DC

charger BEFORE USE

NEVER completely discharge battery as this
will decrease battery life.
The spotlight can be turned on by pressing
push-button switch. Turn off the spotlight by
releasing the push-button switch. For constant
light, keep the push-button switch down, and
then push the fastener lock switch to the right.
NEVER leave switch locked on while not
using light.
To switch off the constant light, move fastener
lock switch back to the left.
The Spotlight contains a 6V6Ah lead acid
battery, which has to be charged before its first
use (Please read the section on recharging).


RECHARGING THE BATTERY:

NEVER completely discharge battery as this
will decrease battery life. If storing for more
than 2 months, periodically recharge battery so
battery will not totally discharge.
Connect the AC power supply OR 12V DC car
plug adapter into the socket located on the
back of the spotlight below the LED; then,
plug the AC power supply into an AC wall
outlet or the 12V DC car plug adapter into the
car 12V DC cigarette lighter socket; As soon
as the charger has been connected, the red
LED light in the spotlight body will light up
indicating charging is in process. As soon as
charging cycle completes, the red LED light
will get dim.
CHARGING TIME is approximately 20
hours using the AC charger and 12 hours using
the DC charger.
DISCONNECT SPOTLIGHT WHEN
CHARGING IS COMPLETE.

CHANGING THE BATTERY:

Carefully remove the 4 screws from the
bottom battery compartment. Disconnect the
battery from the terminals. Replace with
another 6V6Ah lead acid battery and re-
connect the battery terminal (red color wire to
red terminal, black color wire to black color
terminal). Charge BEFORE USE.


CHANGING THE BULB:

Remove the rubber bezel of the light head,
remove the battery compartment from the
bottom, and then loosen the 6 screws on the
side of the body. Open the container and
remove the split pin on the back of the
reflector. Loosen the screw and remove the
lamp wire from the holder. To remove the
light bulb, pull out the flat socket from the
spring clip. Insert a new H3-6V 100W Quartz
halogen bulb. Then repeat the above steps in
reverse order to assemble the spotlight.


NEVER TURN ON OR USE THE
LIGHT WHILE CHARGING as this
will damage unit and void warranty.


SPOTLIGHT MAXIMUM working time when
fully charged is 30 minutes.

If storing for more than 2 months, periodically
recharge battery so battery will not totally
discharge.

REPLACEMENT PARTS:

41-0796 6V 6Ah battery
41-8086 AC Adaptor 120V 300 mA
UL/CUL
41-8087 DC Adaptor for Auto
41-0081 H3 6V 100 Watt Halogen Bulb

41-1088

5 Million Candle Power

Spotlight

www.dorcy.com

Dorcy International

Columbus, Ohio 43217

Advertising