ILUMINARC Ilumipod™ Inground Tri-12 IP - Manual (Page 17)

Operation
Ilumipod Inground Tri-12 IP Optic WW User Manual Rev. 3 13
4. Operation
When you scroll
through the
menu options,
you will see
many of them that do not
correspond with the menu
map. Skip them, as they
do not work with the
WW-only output products.
Ilumicode Addresser
The Ilumipod Inground Tri-12 IP Optic WW needs an external controller, the Ilumicode
addresser (“Ilumicode”), to change its configuration.
Ilumicode Panel Description
Button Function
<MENU> Exits from the current menu or function.
<ENTER>
Enables the currently displayed menu or sets the
currently selected value into the selected
function.
<UP>
Navigates upwards through the menu list and
increases the numeric value when in a function.
<DOWN>
Navigates downwards through the menu list and
decreases the numeric value when in a function.
<POWER>
Turns the unit on. The unit will turn off
automatically after 30 seconds of inactivity.
Control Options
You can set the Ilumipod Inground Tri-12 IP Optic WW start address in the 001~512 DMX
range. This allows for the control of up to 512 products in the 1-channel SOLID personality.
Programming
Carry out all the programming procedures indicated below from the control panel. See the
Menu Map section to learn how the menu options relate to each other.
Use <ENTER> and <MENU> to change levels in the Menu Map, moving right and left
respectively. Use <UP> and <DOWN> to move vertically within the Menu Map.
DMX Personality
1. Go to PERS and select SOLID personality.
2. Make sure to rearrange the DMX addresses of all products in the current DMX
universe to avoid address overlapping.
DMX Starting Address
1. Go to DMX.
2. Select a starting DMX address (001~512).