Junger Audio D*AP4 FLX / D*AP4 LM Edition - Manual (Page 69)

D*AP4
64
Setup GUI – EVENTS – Events – Preset Events
A preset event is a group of presets you may load at one occasion to the On Air parameters of function
blocks. When executing such an event you may for example change the Equalizer, compressor and EQ
settings, by simply assigning the individual preset of your choice to the processing block or the system, to
an interface, to the routing, to the program path or even to the monitor output:
The example shows a preset event with the given
name "LM off".
It was created from an empty event.
Only one preset is involved in this example.
The preset named "LM OFF" is selected for the
function block Level Magic.
It was programmed before at the
AUDIO PROCESSOR > Level Magic tab, by simply
disabling the Leveler check box.
Some blocks have empty selection drop downs
because nothing is selected while others don't have
such drop down at all because no presets
exists there.
Here you have the possibility to reconfigure the D*AP4 completely, partially or to change a few audio
parameters marginally. Reconfigure also means you can use this part to create Events
which act like snap shots!
You are able to create a new preset event by pressing <create event>:
Event name [Snap 1]
A unique name to address this preset
event later in the action manager.
.
Use Settings from [ON Air / Existing Event / Empty]
On Air The events manager will copy
all On Air parameters to new presets
in all function blocks (that have been
selected via the "Include" check
boxes).
.
Existing Event you will be asked from which event it
originated. The presets of the
selected event will be copied to the
new event and may be marginally
tuned afterwards to form a slightly
different event.
Empty Creates a set of empty fields where you may select the preset of
your choice for the respective function block or leave it empty if no
changes are needed …