nMediaPC HTPC 8000 - Manual (Page 4)

4
Step 4: Connect Cables
Following your motherboard user guide to:
Connect Card Reader & USB Ports
z
There are two 10 pins USB connectors. One
for the card reader and USB, the other for
the other two USB ports
z
Match the pin label (on connector) and your
board user guide USB port layout for
accuracy. Red wire is always = “+5V”; Black
= “GND”
Connect IEEE 1394 Port
z
There is one 10 pins 1394 connector
z
Match the pin label (on connector) and your
board user guide 1394 port layout for
accuracy. (Not all board has onboard 1394
port, leave It unplug if you don’t have it)
Connect HD Audio and e SATA Port
z
There is one SATA connector, connect it to
your onboard SATA port
Check your board to see if it has HD onboard
port that supports HD audio
z
If yes, plug the HD connector to your HD
onboard audio port
z
If no, plug it to your AC 97 chipset onboard