Piper 3-CM - Manual (Page 8)

MAINTENANCE
Piper equipment is constructed with the best quality materials and is designed to provide you with
durable service when treated with ordinary care. To obtain the best performance from your equipment,
it should be cleaned daily and maintained in good condition.
CAUTION: Prior to cleaning or maintenance, turn all switches "OFF" and disconnect the power cord
from the receptacle.
WARNING: Do not use any chlorinated or highly caustic cleaners, acids, ammonia or other corrosive
cleaners. These may cause corrosion and/or damage to the stain less steel well. Use only cleaners
approved for stainless steel. Do no allow water to stand in wells for long periods of time. Water must
be removed from well and the well cleaned after every serving period.
GENERAL CLEANING
CAUTION: Use only cleaning agents approved for aluminum and stainless steel. Do NOT use
chlorinated cleaners.
A. Clean the well using a soft cloth or sponge with a mild detergent. Rinse completely with warm
water and then dry.
B. A plastic scouring pad and a mild detergent may be used to remove any hardened food or scale
deposits.
NOTICE: Do NOT use steel wool to clean wells.
C. Use a soft cloth or sponge with a mild detergent to clean all exposed surfaces of the table.
Rinse completely with warm water and dry.
CAUTION: The louvered panels may have sharp edges and could cause injury. Do NOT run fingers
along edges and use gloves when cleaning.
D. Wipe the cord and plug using a cloth with detergent and warm water. Do NOT use excessive
water.
CLEANING ACRYLIC PROTECTOR GUARDS
WARNING: Do NOT use window cleaning sprays, kitchen scouring compounds or solvents such as
acetone, gasoline, benzene or lacquer thinner.
A. Use a soft cloth and mild detergent with plenty of lukewarm water to clean protector guards.
B. Rinse thoroughly with lots of water and dry by blotting with a damp cloth or chamois.
C. Protect and maintain the surface gloss by occasionally waxing with a good paste wax. Apply a
thin even coat with a soft clean cloth and polish with cotton flannel. Wipe with a damp cloth
to help eliminate electrostatic charges.
D. Fine scratches can be removed by hand polishing. Apply a compound such as Simonize cleaner
to a soft flannel pad and rub. When the scratches have disappeared, remove all residue and
polish.