Saturn ST-CC7122 Areio - Manual (Page 2)

2 3
GB
IRON
DEAR BUYER
Dear Buyer!
We congratulate you on having
bought the device under trade name
«Saturn». We are sure that our
devices will become safe and
reliable assistance in your
housekeeping.
Avoid extreme temperature
changes. Rapid temperature change
(e.g. when the unit is moved from
freezing temperature to a warm
room) may cause condensation
inside the unit and a malfunction
when it is switched on. In this case
leave the unit at room temperature
for at least 1.5 hours before
switching it on.
If the unit has been in transit, leave
it indoors for at least 1.5 hours
before starting operation.
1. Temperature control dial
2. Burst of steam button
3. Spray button
4. Spray nozzle
5. Water inlet
6. Pilot light
7. Variable steam control
8. Sole plate
9. Housing
10. Water tank
IMPORTANT SAFEGUARDS
1. Please read all instructions carefully
before using the appliance for the first
time.
2. Before connecting the appliance,
check if the voltage indicated on the
rating plate corresponds with the mains
voltage in your home.
3. Do not use appliance for anything
other than intended use.
4. The iron should always be switched
off before connecting or disconnecting
from the power supply. Do not pull on
the cord to disconnect the plug from the
wall socket.
5. If the power cord is damaged or
defective, it must be replaced by an
authorized service center to avoid a
hazard.
6. When you have finished ironing or
when you are leaving iron unattended:
-turn the variable steam control (7) to
position "and the temperature control
dial (1) to min
-stand the iron upright,
-disconnect the iron from the wall
outlet.
7. The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance.
8. Do not immerse the iron or the cord
into water or any other liquid.
9. Do not touch hot metal parts, hot
water or steam. These parts become hot
and may cause bums. Take care if you
turn the iron upside downs: there may
be not hot water in the tank.
10. The plug and cord should not be
allowed to touch the hot sole plate. Let
the iron cool down completely before
taking K away. Roll the power cord
around the iron for storage.
11. Disconnect the iron from the wall
outlet while filling with water or when
emptying the water after use.
12. To avoid an overloaded circuit, do
not operate another high voltage
appliance in the same electric circuit.
13. Never use an extension power cord
set that is not approved by a competent
authority. The cord should be arranged
in a way that is cannot be pulled or
tripped over.
14. When placing the iron on its stand,
ensure that the surface on which the
stand is placed is stable.
15. The iron is not to be used if it has
been dropped, if there are visible signs
of damage or if it is leaking.
16. The iron must be used and rested
on a stable surface.