Saturn ST-HC7381 - Manual (Page 2)

2 3
GB
HAIR CLIPPER
Dear Buyer!
We congratulate you on having
bought the device under trade name
«Saturn». We are sure that our de-
vices will become faithful and relia-
ble assistance in your housekeep-
ing.
Avoid extreme temperature chang-
es. Rapid temperature change (e.g.
when the unit is moved from freez-
ing temperature to a warm room)
may cause condensation inside the
unit and a malfunction when it is
switched on. In this case leave the
unit at room temperature for at
least 1.5 hours before switching it
on.If the unit has been in transit,
leave it indoors for at least 1.5
hours before starting operation.
Description
1. Cutting head
2. On/off switch
3. Charging contacts
4. Charging stand
5. Control lamp
6. Clip-on comb attachment
PREPARING FOR USE
1. The appliance as supplied by the
manufacturer is not yet ready for use.
It must be electrically charged prior
to use.
2. Insert the plug of the battery
charging stand 4 into a socket. Warn-
ing! This appliance must be charged at
the specified voltage! You can store the
remainder the charging stand 4 (220-
230V, 50Hz). In order to charge the
appliance, it should be placed in the
battery charging stand 4, so that the
control lamp 5 lights up. While the ap-
pliance is being charged, the switch
must be set at "0" ("0" must be visible).
A charging period of 16 hours is re-
quired before initial use. Take care to
keep the charging contacts 3 clean, as
soiled charging contacts can interfere
with the charging process. Overcharging
of the appliance is not possible.
3. After charging the appliance is
ready for use. It can be used with or
without the clip-on comb attachment. To
attach the clip-on comb attachment,
slide it onto the cutting head 1 until it
clicks into position. The appliance must
be switched off while the clip-on comb
attachment is being attached or re-
moved.
4. The clip-on comb attachment is
easily adjustable. Simply slide it up or
down the cutting head 1. The hair can
be cut to 4 different lengths ranging
from approximately 3 mm to 6 mm. The
position of the clip-on comb attachment
on the cutting head determines the
length of the haircut.
5. After using the appliance, switch it
off and replace it in the battery charging
stand 4 to be recharged the control
lamp 5 must light up. In order to retain
the load capacity of the storage battery
we recommend to use the storage bat-
tery until it is empty before reloading .
Figure 1
REPLACING THE CUTTING HEAD
Switch the appliance off before re-
placing the cutting head!
If the performance of the appliance de-
teriorates after extended use, despite
regular cleaning and maintenance, the