SENRUN EP-300-350 - Manual (Page 4)

2
BL CG
MAIN VOL.
MAX
OFF
ON
TONE
L H
DC IN
19V/3.15A
AUX
IN
AF MIX
OUT
9
11
3 1
5 1
1
3
5
7
PW
RF
PW
RF
B-MIC A-MIC
CH.
ON
OFF
MAX
VOL.
ON
OFF
MAX
VOL.
9
11
3 1
5 1
1
3
5
7
CH.
Operation and Controls (UHF)
A. (EP-300/U1.EP-300/U2.EP-300USB) Wireless Receiver Module
Wireless receiver module of switches
and wireless microphone of volume
controls.
16 user selectable channels
Power status LED.
The wireless signal receiver LED－
when wireless microphone is on, the
radio frequency of the receiver will be
illuminated.
B. (EP-300A.EP-300/U1.EP-300/U2.EP-300USB) Master Controls
3.5mm audio input jack.
(USB-MP3/ CD/DVD/ TAPE devices)
3.5mm mixer output jack.
(To record or expanding to a PA system)
- Rotate knob clockwise to
increase to desired level.
Power ON- OFF switch and main
volume control.
Power status LED.
Charging status LED.
The DC rectifier input jack. (DC IN).
(19V / 2.3Ah ).
TREBLE
TREBLE
C. (EP-300USB / EP-350USB) USB disk
(EP-350/U1.EP-350/U2.EP-350USB)
(EP-350A.EP-350/U1.EP-350/U2.EP-350USB)
Error
Repeat
8
1 USB connection port: Insert any USB device; the USB
device must be compatible to USB mass storage device.
2 Power ON/ OFF/ VOL: Turn it clockwise to high volume
up which is turning it on or turn it to anticlockwise to
reduce volume until off position.
3 Rewind mode: Press button to rewind search music songs.
4 Forward mode: Press button to forward search music songs.
5 Play/ Pause: Start to play or pause to play.
6 EQ/ Repeat: To choosing jazz/ pop/ classic/ rock equalizer
mode or 3 seconds to the single repeat and repeat all music
songs by pressing up.
7 Stop: Stop playing songs while it is on playing mode or stop all.
8 Error LED indicator: The red light indicator will flash on while
it is error reading or playing.
3
OFF ON
Tie-clip microphones:
BM-103(3.5mm)
BM-303(3 pin)
Headset microphones:
HM-11(3.5mm)
HM-22(3 pin)
HM-33(3 pin)
UHF Transmitters (Optional)
Steel grille cover: Protect capsule to prevent any damage.
Middle housing: Turn anti-clockwise to inserting the batteries
and ensure the electrode.
Power electric consumption indicator LED: This red light
indicator steady when the batteries are almost out of power.
When the green light indicator lights up, shows that supplies
power normally.
Power switch: ON-OFF switch.
Note: Remove the batteries if you do not plan to use the unit for
a long period of time, please do turn it to off position. Otherwise,
it causes to damage the circuit designed.
A Wireless handheld microphone
、
Body-pack transmitter with matching microphones
A. Tie-Clip microphone B. Headset microphone
External antenna jack: The antenna type is 1/4 input jack.
A. Power status LED: The green light will be light up when
power is on.
B. Low power consumption: State red light indicator, when
the batteries are almost out of power.
3 pin microphone input jack.
Volume control: Adjust by turning clockwise to the volume
knob.
Power switch: ON-OFF switch.
Battery compartment: 1.5V*2 pieces, Ni-MH battery
rechargeable batteries 1.2*2 pieces.
B Body-pack transmitters
、
6
Note on unit operation: when using tie-clip microphone, try to place capsule close to the mouth
while doing so, or do not turn high up the volume as it can not achieve the best reception.
Note: remove the batteries when not been used for a long
period of time to keep the batteries life longer and to avoid
oxidizing of the batteries.
EP-300/350 series