頁面 7, Operation and controls (vhf), Vhf transmitters (optional) – SENRUN EP-300-350 User Manual

Page 7: Wireless receiver module b, Master controls, Awireless handheld microphone, Bbody-pack transmitters, 5mm mixer output jack

Advertising
background image

4

BL CG

MAIN VOL.

MAX

OFF

ON

TONE

L

H

DC IN

19V/3.15A

AUX

IN

AF MIX

OUT

PW

RF

PW

RF

B-MIC

A-MIC

ON

OFF

MAX

VOL.

ON

OFF

MAX

VOL.

Operation and Controls (VHF)

A.

(EP-300/V1.EP-300/V2)

Wireless Receiver Module

B.

(EP-300/V1.EP-300/V2)

Master Controls

Wireless receiver module of switches
and wireless microphone of volume
controls.
Power status LED.
The wireless signal receiver LED-
when wireless microphone is on, the
radio frequency of the receiver will be
illuminated.

3.5mm audio input jack.

(USB-MP3/ CD/DVD/ TAPE devices)

3.5mm mixer output jack.

(To record or expanding to a PA system)

- Rotate knob clockwise to

increase TREBLE to desired level.
Power ON- OFF switch and main
volume control.
Power status LED.
Charging status LED.
The DC rectifier input jack. (DC IN).
(19V / 2.3Ah ).

TREBLE

(EP-350/V1.EP-350/V2)

(EP-350/V1.EP-350/V2)

5

006P

9V

6

VHF Transmitters (Optional)

Steel grille cover: Protect capsule to prevent any damage.
Power status LED: This red light indicator steady when the
batteries are almost out of power. When the green light
indicator lights up, shows that supplies power normally.
Power switch: ON-OFF switch.
Battery compartment: 9V*1 piece. Turn anti-clockwise to
inserting the battery and ensure the electrode.

A

Wireless handheld microphone

Note: Remove the batteries if you do not plan to use the unit
for a long period of time, please do turn it to off position.
Otherwise, it cause to damage the circuit designed.

Tie-clip microphones:

BM-103(3.5mm)

BM-303(3 pin)

Headset microphones:

HM-11(3.5mm)

HM-22(3 pin)

HM-33(3 pin)

Body-pack transmitter with matching microphones

A. Tie-Clip microphone

B. Headset microphone

External antenna jack: The antenna type is 1/4 input jack.
A. Power status LED: The green light will be light up when
power is on.
B. Low power consumption: State red light indicator, when
the batteries are almost out of power.
3 pin microphone input jack.
Volume control: Adjust by turning clockwise to the volume
knob.
Power switch: ON-OFF switch.
Battery compartment: 1.5V*2 pieces, Ni-MH battery
rechargeable batteries 1.2*2 pieces.

B

Body-pack transmitters

Note on unit operation: when using tie-clip microphone, try to place capsule close to the mouth
while doing so, or do not turn high up the volume as it can not achieve the best reception.

Note: remove the batteries when not been used for a long
period of time to keep the batteries life longer and to avoid
oxidizing of the batteries.

EP-300/350 series

Advertising