SMK-Link Electronics RemotePoint Ruby Presenter - Manual (Page 3)

Page 3 Page 4
Step 2
Plug In the Receiver
• Retrieve the USB receiver
dongle from the built-in storage
bay on the Presenter.
•
Connect the USB receiver
dongle to an available USB port
on your computer. Wait for
the computer to go through its
default process of recognizing
the new hardware and installing
the built-in native driver.
•
Power on the Presenter by sliding
the On/Off switch to On position.
• The Presenter and the receiver
dongle come pre-paired at the
factory. The Presenter should
be functioning at this point.
Step 1
Install the Batteries
(Supplied)
• Open the battery compartment
by pressing down the
cover latch and sliding the
door off the Presenter.
• Insert the two supplied AAA
batteries to the battery slots.
• Make sure the positive (+) and
negative (-) ends of the batteries
match the polarity markings
inside the battery compartment.
• Slide the battery cover
back into position.
Slide the battery cover off
Insert the batteries
Power on/off switch
USB receiver