TabletKiosk eo a7400 - Manual (Page 5)

When using a touch screen, tap once on the input panel’s edge to slide it to the center of your
desktop. You can also enable the PC Input Panel Toolbar on the Windows Taskbar by pressing
and holding (right-clicking) on a blank space on the Taskbar and choosing "Toolbars ž Tablet
PC Input Panel" from the pop-up menu that appears.
For more information on using the input panels, see the digital User's Guide on your system's
desktop (you can also download it from
www.tabletkiosk.com ) or check out the Tablet PC
Tutorials in Windows.
Calibrating the Screen for Improved Accuracy
If you find that the position of the on-screen pointer
isn’t matching the touch of the stylus or your finger
properly, you should calibrate the screen.
Calibrating the Active Digitizer and Touch Screen
1.
Go to the START menu and tap on "Control
Panel" in the right hand column to open the
Windows Control Panel.
2. Tap on the “Hardware and Sound” category and
locate the "Tablet PC Settings" sub-category and
then either tap on it or tap on the "Calibrate the
screen for pen or touch input" link.
3. In the "Display" tab, tap on the “Calibrate...”
button. If a Window appears asking you which
type of screen you to want to calibrate ("Touch
Input" for the touch screen, or "Pen Input" for
the digitizer) choose the appropriate one to
continue to the calibration screen.
4. Follow the on-screen instructions to complete
the calibration. The routine for each screen is
very similar. Tap in the center of each cross
when it appears on the screen. When you have
tapped on the last cross, you will be prompted to save your calibration data. If you are
happy with how you tapped on each cross, save the data. If not, choose to cancel and then
rerun the calibration routine.
NOTE: If you find that after you calibrate for the first time the screen accuracy is no better or perhaps
worse, choose to calibrate again. After the first calibration for each screen, the routine steps down to
only using 4-target points for calibration. Sometimes, the 4-point calibration can produce better feeling
calibration data for some users.
If at any point you wish to reset your calibration data and return to the Windows default
calibration state, simply tap on the "Reset..." button and choose which screen to reset if asked.
Connecting to a Wireless Network
1.
Turn on the WiFi transmitter by sliding the
toggle switch on the top of your tablet to the
left.
2. In the Windows 7 System Tray, tap on the
“Wireless Networks” (
) icon.
3. From the list that appears, tap to select the net-
work to which you wish to connect and then
tap the “Connect” button.
If your eo a7400 has a dual mode screen, you
will see this window asking you to choose an
input panel to calibrate.