TabletKiosk eo a7330 Ultra-Mobile - Manual (Page 6)

2. In the System Tray, tap on the Intel PROSet icon ( ) and choose “Configure WiFi” from
the pop-up menu that appears.
3. When the Intel® PROSet/Wireless WiFi Connection Utility opens, choose the network from
the list that you wish to connect to and tap the “Connect” button. If no wireless networks
appear after a few moments, tap on the “Refresh” button located just below the list.
4. If the wireless network you are attempting to connect to is security-enabled, you will see
a dialog box requesting either a network key or, if the wireless network supports WiFi
Protected Setup (WPS), a PIN.
Most failures to connect to a wireless network occur because the network key has been
improperly entered. Be very careful when entering this key. If you do not know the correct
key to enter, or still can’t connect after entering the key properly, contact your network
administrator or the technical support line of your Internet Service Provider.
NOTE: If your network access point or router uses WiFi Protected Set-up, the WPS Wizard will
appear on the screen. Choose your access point from the drop-down list, enter your PIN when
prompted. Unless you need to configure your access point/router for the first time, just tap on
the “No” button when asked. If you entered your PIN properly, you should see the same pop-up
window informing you that you are connected. Check with your Network Administrator or the
instructions that came with your access point/router for locating the PIN.
Restoring Your System Using the System Restore Disc
What you will need before you begin:
1. The Windows 7 Professional, Windows XP Professional, or Windows XP Tablet PC Edition
System Restore DVD for the eo a7330 Ultra-Mobile PC.
2. External USB DVD drive with its own power supply (not USB Bus powered)
3. USB keyboard
4. USB mouse (you will also need a USB hub if you don’t have the USB 2x2™ module)
To Restore Your System:
IMPORTANT: This process is destructive to the data stored on your hard drive. All existing
data will be lost. It is vital you back-up any files on your hard drive to an external storage
device or disk that you wish to keep before you proceed.
Step 1: Set up the required hardware:
1. Plug the mouse and keyboard into the USB 2x2 module. Plug the DVD drive into the USB
port on the left side of the eo. If you don’t have the USB 2x2 module installed, you’ll need
to plug everything into the USB Hub and plug the Hub into the USB port on the left side
of the eo. Power on the DVD drive and insert your eo a7330 System Restore Disc.
To Restore Using the Windows 7 Professional Restore Disc:
Step 2: Booting the eo a7330 to the Recovery Application
1. Power up your eo a7330 Ultra-Mobile PC.
2. If your drive has an existing partition (overwriting existing OS):
When prompted press any key to boot to the recovery DVD.
If your drive doesn’t have an existing partition (new drive, no OS):
It will automatically load the recovery application.
3. Select the “Tools” Button and then the “Reset Partition” Button to continue.
4. Enter the partition size you wish to create for your OS. In general, you should use the
number from the “Free Space” box as this will provide you with the largest system parti-
tion possible.