TEKVOX MMX88 Matrix Switcher - Manual (Page 22)

Modular Matrix Switcher 8x8 (with Audio)
17
All@. Switch on all the output.
[x]@. Switch on output [x].
[x1]V[x2].
Transfer the video signals from the input
channel [x1] to the output channel [x2].
[x1]A[x2].
Transfer the audio signals from the input
channel [x1] to the output channel [x2].
[x1]B[x2].
Transfer signal from the input channel [x1] to the
output channel [x2].
Status[x].
Inquire the input channel to the output channel
[x].
Status.
Inquire the input channel to the output channels
one by one.
Save[Y].
Save the present operation to the preset
command [Y]. [Y] ranges from 0 to 9.
Recall[Y]. Recall the preset command [Y].
Clear[Y]. Clear the preset command [Y].
PWON. Work normally.
PWOFF. Enter in standby mode.
HDCPON. Turn on the HDCP output.
HDCPOFF. Turn off the HDCP output.
/V00. Inquire the version of backboard software.
UpgradeIntEDID[x].
Upgrade built-in EDID data. Supports 6 types of
EDID data (see Note 6). When the switcher gets
the command, it will show a message to send
EDID file (.bin file).
EDIDUpgrade[x].
Upgrade EDID data of input ports
When the switcher gets the command, it will
show a message to send EDID file (.bin file).
Operations will be canceled after 10 seconds.
EDID/[x]/[y].
Set the EDID data of input port [x] to built-in
EDID data of type [y].
The value of [y] varies from 1~6. The EDID data
types are same as mentioned above.
EDIDG[x].
Get EDID data from output channel X and
display the data on serial port control software.
[x] is the output port number.
EDIDMInit.
Recover the factory default EDID data for every
input channel.