Toyotomi ETK-S50 - Manual (Page 10)

8
PREPARATION BEFORE USE
1 HOW TO INSTALL THE FILTERS
(Be sure to assemble Filters before using the Air Purifier.)
1 1 Pull the front panel toward you and remove it while
pressing the right and left buttons at the bottom of the
main unit.
2 2 Remove the Prefilter.
3 3 Remove the enzyme HEPA filter and active charcoal
filter in the bag from the main unit.
4 4 Take the enzyme HEPA filter and active charcoal filter
out of the bag and put the thinner active charcoal filter
behind the enzyme HEPA filter, then mount the
enzyme HEPA filter to the main unit according to the
mounting direction ↑ with the green-cloth side to the
front. Mount the Prefilter, too.
5 5 Align the nails located at the top of the front panel to
the main unit, and hang the front panel onto the right
and left hooks at the lower part.
★If the enzyme HEPA filter and active charcoal filter are mounted incorrectly, the filters will
not work properly. Make sure that the green-cloth side of the enzyme HEPA filter is in front.
★Dirty enzyme HEPA filters and active charcoal filters cannot be reused even if they are
washed. Be sure to replace them.
★The enzyme HEPA filters should be replaced about five years after opening the package.
The active charcoal filters should be replaced about two years after opening the package.
The replacement frequency depends on how long they are used or where they are installed.
● The lifetime of the filters will become very short in cases where they absorb oily smoke or
carbonized substances such as soot.
NOTE
Button
Prefilter
Hook
ETK-S50 (GB) 10.6.22 9:03 AM ページ 8