Transystem 747ProS - Manual (Page 7)

1.6 Power Switch and Push Button
Power Switch
Right (Off)
Power off
Middle (Car mode)
When the external power source was connected to 747ProS, it will
be wake up and start logging. In contrast, if 747ProS no any external
power supply, it will forever go into power saving mode.
Left (Smart LOG)
Log time interval will be changed according to the speed detected by
the Device. Speed for each time interval can be programmed by the
provided software.
Push button
Push
Push button to record POI (Points of Interest),
LED will blink 3 times which means the POI is recorded.
1.7 Appearance & LED indication
The 747ProS GPS Trip Recorder has three LED lights, one is Smart Log LED, the 2
nd
one is
Battery Status LED, the 3
rd
one is GPS Status LED/ Push to log LED. The status table of LED
shows as follows:
Blue - Always OFF = Motion sensor OFF
Blue - Blink every 2 seconds = logging, Motion sensor ON
1. Motion
sensor LED
Blue - Blink every 5 seconds = power saving mode
Green - always ON = Charging
Green - OFF = Fully charged
2. Battery
status LED
Red - always ON = Low battery
Orange - always ON = Not Fix and searching for satellite
Orange - Blink every 2 seconds=GPS fix and logging (smart mode)
Orange - Blink every 1 second=GPS fix and logging (car mode)
Orange - OFF = Power saving mode or power off
Red - always ON = memory full
Red - Blink every 2 seconds= 80% memory occupied
3. GPS &
Memory
status LED
Red - Quick blink 3 times = POI recorded
7