Transystem photoMate 887 - Manual (Page 10)

10
2.2 Getting Started
Please follow the procedure step by step.
Step 1 Charging Your Battery
To charge your 887 data logger, you have to plug your USB cable into the
power source. Charging time is about 90 minutes and you can charge
from PC/ Notebook’s USB HOST or from cigarette-lighter in car.
For the 1st time you use the 887, please charge battery until it is full (the
green LED is blinking). Shown in below
- If the LED is red, that means battery power is critically low. Charge immediately.
- If the LED is green, that means battery is charging now.
- If the green LED is blinking, that means battery is fully charged.