Tview D760BD - Manual (Page 11)

17 18
1. To ensure the accurate of touch function, please touch the center point of
relative function.
2. There are build in anti-jamming system in touch screen, To prevent the wrong
position touch, please keep to touch this function for 0.5 second, then the
product will get respond for your instruction.
3. Please do not use the object, which is bigger than the function icon to touch
the screen. Otherwise the touch function will failure or give the wrong operation
to other function.
4. To ensure the panel safety, please don't press or use the sharp object to touch
the panel.
5. Don't play the severity scratch disc, otherwise will damage the DVD play
capability.
6. Be sure to distinguish the anode and the cathode when connecting the power.
If connect wrong, the fuse in filter box will melt immediately to protect unit. Then
please replace the same parameter fuse.
7. DC 12V should be best to connect with the power adapter to prevent from the
over-voltage drop the may influence the normal work of the monitor.
8. Keep this machine away from too hot, or under effect of moisture, dust or oil
smoke, avoid this machine from dropping or impacting, never extrude or chafe
this machine with sharp objects.
9. Dangerous high voltages are present inside the enclosure. Do not open the
cabinet, non-professionals can not disassemble unit
10. Installation should be very tight and secure. Preventing the fallen unit hurt
people when moving on or a sudden brake.
Warning
Disc Notes.
7"
480xR. G. BX234
5°C~45°C
Wor king
temperature
DC: 12V/10A
ALARM
For your safety, driver are advised not to watch the display when driving.
It's prohibited in law of some countries when driving and operating to
watch displayer.
Simple Trouble-Shooting Guide
Symptom Probable Cause Solution
Black Screen
1.No12 voltage
2.Brightness or contrast
ratio is too small
1 .check the power is on or
connect rightly
2. check the A/V Cable
is loose or not
3. Increase the brightness
and contrast ratio
NO picture
1.No sources output
2.The video concentric plug
becomes loose
1.Check the output of VCD
or DVD
2.Replace with the A/Vcable
3.Tighten the Video input
cable
color picture
1 Video sources have
no output
2.Color ratio should be
re-adjust
1.check the video sources
2.Enter into the Menu to
re-adjust
With a little regular light
spots and color spots on
the screen or black
horizontal line in the
picture
It is normal symptom in the
active matrix display
technology.
it is normal symptom in
view range with a little
regular light spots on
display screen.
Unclear picture
1.Poor quality of the
video sources
2.Bright &Contrast 1.Replace with the high
quality videodisc
2.Reset Bright &contrast.
The outer cover of the
monitor has been deformed
1.External temperature is
too high.
2.The power has not been
switched off for a long time.
1.The surround temperature
should not exceed to 0-60
degrees.
2.Turn off the power after
using the unit.
If your product fails, please follow the way of exclusion, if it is still unresolved, please
contact the professional or supplier.