TVLogic SWM-170A - Manual (Page 6)

10 Multi Format LCD Monitor Multi Format LCD Monitor 11
●
[MENU] button
- Used to activate the OSD menu.
- When the OSD menu is activated, press this
button to exit from the menu.
●
[DOWN] Button
- Used to move down through the menus
during the OSD menu activation and also to
decrease the value of the selected feature.
- When the OSD menu is inactivated, this
button is used to activate function that is
selected in Key Function 1.
●
[UP] Button
- Used to move up through the menus during
the OSD menu activation and also to
increase the value of the selected feature.
- When the OSD menu is inactivated, this
button is used to activate function that is
selected in Key Function 2.
●
[ENTER] button
- Used to confirm a chosen value (or mode).
- May also be used to control the Bright/
Contrast/Chroma/Aperture value during the
OSD menu inactivation. Use the UP/DOWN
buttons to adjust the value.
3. Controls & Functions
FRONT RIGHT
●
[STANDBY] lamp
- It affords power supply, which may be
indicated by indication lamp. The lamp is
RED during power supply and GREEN during
system is in operation. In case of power cut
and sudden shut off of the power, our
monitor keep previous setup stage.
●
[POWER] button
- Used to turn power on and off.
●
[USB]
- This terminal is used to upgrade the firmware
or color calibration made by TVLogic.
●
[TALLY] lamp
- LED indicating monitors current status.
3. Controls & Functions
REAR /LEFT
<Warning!!>
When using the product make sure to ground,
whenever possible, before connecting the
input signal cable in order to prevent any
possible damage to the product or connected
devices. The damage may include signal
noise, malfunction of main board or display
panel. And the connected devices such as
camera or video source player may also
be influenced through signal cable. Please
check if the AC power source and the power
extender or power distributor is grounded.
●
[HDMI(HDCP)] (HDMI)
- Signal input terminal for HDMI signal.
●
[DVI-I]
- Signal input terminal for DVI DIGITAL signal.
●
[SDI-A IN] (BNC)
- HD/SD SDI signal input terminal for SDI A.
●
[SDI-A OUT] (BNC)
- HD/SD SDI signal output terminal for SDI A.
●
[SDI-B IN] (BNC)
- HD/SD SDI signal input terminal for SDI B.
●
[SDI-B OUT] (BNC)
- HD/SD SDI signal output terminal for SDI B.
●
[Ethernet IN]
- Ethernet port for easy updates on new
functions and error correction.
●
[Ethernet OUT]
- Supports Ethernet through out function.
●
[REMOTE] (RJ-45)
- Provides connection to control equipment
for external monitor control.
●
[AC IN]
- Used to supply AC power; 100V~240V input
range.
●
[OPTIC] (SFP optical connector, Option)
- Optical Fiber terminal for SDI signal input.