Zilog ZAURCT - Manual (Page 15)

UM022903-0311 ZAURA System Installation and Configuration
ZAURA ™ RF Wireless Lighting Control
Installation Guide
9
ZAURA System Installation and
Configuration
This chapter describes room requirements assessment, battery installation, starter installa-
tion and association, and how to configure and mount your ZAURA masters and range
extenders. The chapter begins with an Installation Summary section, which provides a
blueprint suitable for installers who have previously performed a ZAURA installation.
Installation Summary
The steps in this section summarize the sequence of a typical ZAURA System installation.
Links to additional sections of this document have been added to provide more detailed
assistance.
1. Determine the location of Standard Masters (and Range Extenders, if required). For
additional assistance with this step, see the the Determine Master and Range Extender
Locations section on page 11.
2. Determine luminary configuration. For additional assistance with this step, see the the
Determine Luminary Configuration section on page 13. Items to consider when
configuring your luminaries are:
– Which luminaries, if any, will be using their original starters (consider safety con-
cerns)
– Which luminaries will contain ZAURA Starters
– Which luminaries will contain ZAURA Virtual Dimming Starters (typically for
placement near windows)
3. Inventory your parts (Masters/Range Extenders, Starters, etc.) and tools to ensure that
you have sufficient quantities for the required installation. For additional assistance
with this step, see the the
Inventory Parts and Tools section on page 15.
4. Mount base plate(s) to the ceiling in the location(s) you determined in Step 1 using the
screws or the double-sided tape provided.
1
. For additional assistance with this step,
see the the Mount Base Plates section on page 15.
5. Configure the ZAURA Masters. For additional assistance with this step, see the the
Configuring ZAURA Masters section on page 18.
1. Zilog recommends using the screws provided with the ZAURA System when mounting the Master base plate;
however, double-sided tape is provided with the installation hardware. Simply press the double-sided tape to the
base plate, then mount the base plate securely to the mounting surface to ensure good adherence. Depending on the
mounting surface, however, caution should be used when removing the base plate when it has been affixed with the
double-sided tape, because damage to the Master housing and/or to the mounting surface could occur.