Aesthetix Rhea - Manual (Page 6)

5 second delay and then the display will extinguish. If the standby button was pressed,
the unit will enter the standby mode. The standby light is always illuminated, regardless
of whether the display was on or off.
Pressing the display button while the display is off, or during the 5 second timeout
period, will turn on the display and normal operation will return.
Note: The LED for the display button is intentionally inactive.
Advanced display functionality
This unit contains the ability to sense the ambient light level in the room and adjust the
display and LEDs accordingly. While the factory settings will work for most situations,
there may be times when adjustment to the settings is useful. There are three main
sections to the advanced display functionality:
Adjustment of display brightness
Adjustment of LED brightness
Restoration of the factory default settings
Adjustment of display brightness:
To access this section, first press and hold the “display” button, then concurrently press
“1” button. This can only be done from the front panel. It is recommended that once this
section is entered, that all adjustments be made with the remote at some distance from the
unit, so as not to obstruct light from reaching the sensor. LED #2 will light, and the
display will show two numbers in the range 00-15, one on the left display and one on the
right display. The left number indicates the light level that the sensor is reporting, 0 is
darkest and 15 is brightest. The rightmost number indicates the display brightness setting
for that light level, 0 is darkest and 15 is brightest. LED#2 will be lit, which indicates
that pressing the “up” or “down” buttons will adjust the display brightness for the current
light level. Pressing button #1 will turn on LED#1, which indicates that pressing the
“up” or “down” buttons will change to a different light level setting, for which the
display brightness could then be changed by pressing button #2. Changes to the display
brightness will only be visible for the current light level.
To exit this section, press the “display” button.
Adjustment of LED brightness:
This section works identically to the above “Adjustment of display brightness” except
that adjustment is made to the LED brightness instead of the display.
6