Fcc conformity, Safety precautions – American Time AllSync IQ User Manual
Page 2
© American Time
2
AllSync IQ Installation Manual
FCC Conformity
(USA only)
Safety Precautions
Responsible Party: American Time, 140 3rd St. S., PO Box 707, Dassel, MN 55325-0707 USA
TEL: 320-275-2101, declares that the product(s):
AllSync IQ Master
Comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
All electrical power and signal wiring connected to the AllSync IQ Master, secondary clocks and signaling devices must be installed by
qualified persons in conformance with applicable national and local electrical codes. Improper installation of this equipment can result
in lethal electrical shock and fire.
Disconnect and lock out electrical power to the unit before removing the wiring compartment cover.
Voltage applied to clock and signal relay contacts must not exceed 250vac.
The AllSync IQ Master should be installed in a secure location protected from:
• Physical damage
• Water, including condensation
• Direct sunlight
• Operation by untrained personnel