Amina AIW750i - Manual (Page 24)

Plastering and decorating continued...
04
05
Plastering
Use standard low shrinkage finishing
plaster for large areas. For patch
plastering use a low shrinkage repair
plaster such as British Gypsum Easi-fill®
Please refer to the appropriate page
in Section B (alignment and plastering
preparation for your specific installation
type). Pages 13 - 17
Important: To ensure proper operation and
sonic performance, no more than 2mm
(5/64”) of plaster must be applied to the
surface of the panel.
The working environment must be dry
enough to allow the plaster finish coat to
dry within hours, not days.
For non-standard plaster types please
contact Amina or your distributor.
Never force dry the environment.
Decorating
Allow your plasterwork and surroundings
to dry completely. In reality this will take
several days even though the plaster
appears dry within a few hours. Test the
speaker again (see Section C, page 18).
You can then paint the surface or hang
wallpaper in the usual manner.
Amina invisible speakers have been
optimised for three coats of emulsion once
plastered. Additional coats will cause very
small reductions in the maximum sound
pressure levels achievable.
D
Note:
Amina have separate guides for
information about installing the
product behind other materials and
surfaces such as wooden panels,
acrylic and high pressure melamine
laminates.
Contact Amina if you require any
additional information (page 32)
20