Denon AV SURROUND RECEIVER AVR-5308CI - Manual (Page 38)


Get
ting Star
ted
Connections
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
g Manual EQ
Adjust tonal quality for each speaker using graphic equalizer.
Adjust CH
Select speaker adjustment method.
[Selectable items] Each L/R All
Select the speaker and frequency band and adjust the level.
[Selectable items]
63Hz 125Hz 250Hz 500Hz 1kHz 2kHz 4kHz 8kHz
16kHz
[Variable range]
–20dB ~ 0dB ~ +6dB
Curve Copy
Copy the Room EQ’s “Audyssey Flat” correction curve.
[Selectable items] Yes No
“Curve Copy” is displayed after the auto setup procedure has been
performed.
Default
Resets the settings to the default values.
Set
up
1
Connect the LAN cable (vpage 22).
2
Turn on the AVR-5308CI (vpage 56).
AVR-5308CI performs automatic network setup due to the DHCP
function.
When connecting to a network that has no DHCP function,
perform the setting in step 3.
3 Set the IP address at the GUI menu “Manual Setup”
“Network Setup” – “Network Setup”.
q Select “Detail” and press ENTER .
w Use o p to set “DHCP” to “OFF”, then press i.
The DHCP function is disabled.
Network Setup
Make network settings.
F Menu tree F
Manual Setup
Network Setup
a Network Setup
s Other
d Network Information
a Network Setup
Make settings for wired or wireless LAN.
Wired LAN settings
Use this procedure to confi gure the Wired LAN settings.
• DHCP (Dynamic Host Confi guration Protocol) :
These are systems by which the IP address and other network
settings are automatically set for the AVR-5308CI, computer,
broadband router and network devices.
• DNS (Domain Name System) :
This is a system for converting the domain names used when
browsing Internet sites (for example, “www.denon.jp”) into the
IP addresses actually used for communications (for example,
“202.221.192.106”).
q Select “Detail”.
e Input the address.
r Select “Exit”.
w Set “OFF”.
• If you are using a broadband router (DHCP function), there is no need
to make the settings at “Setting the IP Address” and “Setting the
Proxy”, since the DHCP function is set to “ON” in the AVR-5308CI’s
default settings.
• If the AVR-5308CI is being used connected to a network without the
DHCP function, the network settings must be made. In this case,
some knowledge of networks is required. For details, consult a
network administrator.
• If you cannot connect to the Internet, recheck the connections and
settings (vpage 22).
• If you do not understand about Internet connection, contact your ISP
(Internet Service Provider) or the store from which you purchased
your computer.
AVR5308CIEU_100_初校作成中.indd 35 2008/05/26 9:40:38