Artesyn MVME2502 Installation and Use (April 2015) - Manual (Page 82)

Controls, LEDs, and Connectors
MVME2502 Installation and Use (6806800R96E) 82
5 OFF (133 MHz) PMC_133 PCI frequency selection This option can only be used
if the PMC supports PCI-X
interface. The board will
automatically detect the
frequency of operation of
the PMC and the board will
negotiate accordingly. If the
PMC support PCI-X speed,
this switch can be
configured to run either 100
MHz or 133MHz frequency.
6 OFF (WP Enabled) MASTER_WP_DISA
BLED The on-board EEPROM can
be write-protected via S2-
6, switching it ON will
disable the write
protection. For I2C write-protect only.
7 OFF (Front) GBE_MUX_SEL User Defined switch that
will select if the GBE PHY
will function on the front
panel or on the Back
PLANE
8 OFF (CPU Reset
Deasserted) Reserved Should be "OFF" for normal
operation.
Table 3-19 Geographical Address Switch Settings (continued)
SW2 DEFAULT Signal Name Description Notes