Artesyn MVME6100 Single Board Computer Installation and Use (June 2014) - Manual (Page 20)

Hardware Preparation and Installation
MVME6100 Single Board Computer Installation and Use (6806800D58H) 20
1.4 Getting Started
This section provides an overview of the steps necessary to install and power up the
MVME6100 and a brief section on unpacking and ESD precautions.
1.4.1 Overview of Startup Procedures
The following table lists the things you will need to do before you can use this board and tells
where to find the information you need to perform each step. Be sure to read this entire
chapter, including all Caution and Warning notes, before you begin.
1.4.2 Unpacking Guidelines
Unpack the equipment from the shipping carton. Refer to the packing list and verify that all
items are present. Save the packing material for storing and reshipping of equipment.
Table 1-1 Startup Overview
What you need to do... Refer to...
Unpack the hardware. Unpacking Guidelines on page 20
Configure the hardware by setting jumpers on the board. Configuring the Hardware on page 21
Install the MVME6100 board in a chassis. Installing the Blade on page 30
Connect any other equipment you will be using Connecting to Peripherals on page 30
Verify the hardware is installed. Completing the Installation on page 31