Artesyn NITX-315/NITX-315-ET Installation and Use (August 2014) User Manual
Artesyn Equipment
Advertising
Table of contents
Document Outline
- NITX-315/NITX-315-ET
- Contents
- About this Manual
- Introduction
- Hardware Preparation and Installation
- Controls, LEDs, and Connectors
- 3.1 Board Layout
- 3.2 Connectors and Switches
- 3.2.1 S2 Switch Settings
- 3.2.2 LVDS Header (P28)
- 3.2.3 LVDS Backlight Header (P23)
- 3.2.4 LVDS Power Header (P5)
- 3.2.5 USB client header (P18)
- 3.2.6 CPU JTAG header (P20) - Optional
- 3.2.7 USB Header (P6)
- 3.2.8 eUSB Header (P2)
- 3.2.9 Audio Header (P12)
- 3.2.10 CAN Bus Header (P15)
- 3.2.11 SPI Program Header (P21)
- 3.2.12 Full Wire RS232 Header (P7)
- 3.2.13 Two Wire RS232 Header (P14)
- 3.2.14 SDIO Header (P16)
- 3.2.15 Battery Header (P17)
- 3.2.16 Front Panel Header (P19)
- 3.2.17 GPIO Header (P4)
- 3.2.18 TPM Header (P8)
- 3.2.19 CPU FAN Header (P1)
- 3.2.20 ATX 4-Pin Power Header (J4)
- 3.2.21 SATA Power Header (P16)
- 3.2.22 I2C Header (P9)
- 3.2.23 J9 SATA Connector
- 3.3 Onboard LEDs
- Functional Description
- 4.1 Block Diagram
- 4.2 Processor
- 4.3 System Memory
- 4.4 PCI-E Port
- 4.5 SATA
- 4.6 MicroSD
- 4.7 Ethernet Interfaces
- 4.8 USB Interface
- 4.9 USB Flash
- 4.10 RS-232
- 4.11 CAN bus
- 4.12 I2C Serial Interface and Devices
- 4.13 Video Interface
- 4.14 Audio Interface
- 4.15 TPM Interface
- 4.16 BIOS Device
- 4.17 GPIO Configuration
- 4.18 Clock Distribution
- BIOS
- Operating System and Driver Support
- A Replacing the Battery
- B Related Documentation
- Safety Notes
- Sicherheitshinweise