Artesyn NITX-315/NITX-315-ET Installation and Use (August 2014) - Manual (Page 98)

BIOS
NITX-315/NITX-315-ET Installation and Use (6806800L71D) 98
0xA8 SCSI Enable
0xA9 Setup Verifying Password
0xAA Reserved for ASL (see ASL Status Codes section below)
0xAB Start of Setup
0xAC Setup Input Wait
0xAD Ready To Boot event
0xAE Legacy Boot event
0xAF Exit Boot Services event
0xB0 Runtime Set Virtual Address MAP Begin
0xB1 Runtime Set Virtual Address MAP End
0xB2 Legacy Option ROM Initialization
0xB3 System Reset
0xB4 USB hot plug
0xB5 PCI bus hot plug
0xB6 Clean-up of NVRAM
0xB7 Configuration Reset (reset of NVRAM settings)
0xB8 Reserved for future AMI codes
0xC0 OEM BDS initialization codes
DXE Error Codes
0xD0 CPU initialization error
0xD1 North Bridge initialization error
0xD2 South Bridge initialization error
0xD3 Some of the Architectural Protocols are not available
0xD4 PCI resource allocation error. Out of Resources
0xD5 No Space for Legacy Option ROM
0xD6 No Console Output Devices are found
0xD7 No Console Input Devices are found
Table 5-30 DXE Status Codes (continued)
Status Code Description