Artesyn PCIE-8120 Installation and Use (July 2014) - Manual (Page 95)

Safety Notes
PCIE-8120 Installation and Use (6806800R89C) 95
Installation
Damage of Circuits
Electrostatic discharge and incorrect installation and removal of the product can damage
circuits or shorten their life.
Before touching the product or electronic components, make sure that your are working in an
ESD-safe environment.
Product Damage
Incorrect installation of the product can cause damage of the product.
Only use appropriate tools when installing/removing the product to avoid
damage/deformation to the card and/or PCB.
Cabling and Connectors
Product Damage
The RJ-45 connector(s) on the card are twisted-pair Ethernet (TPE) or interfaces. Connecting
an E1/T1/J1 line to an Ethernet connector may damage the product.
 Make sure that TPE connectors near your working area are clearly marked as network
connectors.
 Verify that the length of an electric cable connected to a TPE bushing does not exceed 100
m.
 Make sure the TPE bushing of the product is connected only to safety extra low voltage
circuits (SELV circuits).
If in doubt, ask your system administrator.
Environment
Always dispose equipment that is finally taken out of operation according to your country’s
legislation and manufacturer’s instructions.