Avalon Firestyles 1750 Spokane - Manual (Page 21)

Operating Your Appliance 21
© Travis Industries 100-01234 4141211
Ash Removal
ASHES
Whenever ashes get 3 to 4 inches deep in your firebox or ash pan, and when the fire has burned
down and cooled, remove excess ashes. Leave an ash bed approximately 1 inch deep on the
firebox bottom to help maintain a hot charcoal bed. Let the stove cool completely before
removing ashes (wait at least two hours after the last coal has extinguished). Ashes should be
placed in a metal container with a tight-fitting lid. The closed container of ashes should be placed
on a noncombustible floor or on the ground, away from all combustible materials, pending final
disposal. The ashes should be retained in the closed container until all cinders have thoroughly
cooled.
Optional Blower Operation
The blower will turn on once the stove is up to temperature. This is typically 15 to 30 minutes after
starting the fire. Follow the directions below to alter the blower speed.
OFF
Turn the dial all the way counter-
clockwise until it clicks off.
BLOWER
CONTROL
LO
OFF HI
HIGH
The high position is all the way counter-
clockwise, without clicking off.
BLOWER
CONTROL
LO
OFF HI
LOW
Turn the dial all the
way clockwise.
BLOWER
CONTROL
LO
OFF HI
The blower may be used to affect heat output (i.e.: to reduce heat output, turn the blower down).
Route the power cord in a location where it will not come in contact with the appliance or become hot.