Avalon Firestyles 1750 Spokane - Manual (Page 31)

Maintaining Your Appliance 31
© Travis Industries 100-01234 4141211
Baffle Removal & Replacement
1 Push the front firebricks up and feed them forward, guiding them out the door. Repeat for the
rear firebricks.
Baffle Firebrick
Front Baffle Support
Center Baffle Support
Bypass Support
Front Air Tube
Support Tabs
Bypass Damper
Bypass Rod (& Yoke)
Bypass Gasket
2 The baffle supports rest on support tabs.
3 The bypass support and damper are difficult to remove and should only be removed if necessary.
Remove the rear secondary air tube (see the following section for instructions). Slide the bypass
support forward until the bypass rod can be disconnected from the bypass damper. Slide the
damper forward and remove. The bypass support is removed by sliding it forward and rotating it
downwards (the bypass holder fits very snug inside the firebox and is very heavy, making it
difficult to remove). The bypass gasket rests on the side and rear air channels. Try not to
damage it when removing the bypass holder.
Air Tube Removal & Replacement
a
b
Remove the left pin on the air tube collar
Air Tube Collar
Air Tube
Slide the air tube to the left, swing it
down and remove from the firebox.
Roll Pin