Avery Dennison Pathfinder 6057 Operator Handbook - Manual (Page 26)

To clean the printhead:
1. Turn off the printer.
2. Open the supply cover and remove the supplies.
3. Check the supply holder for adhesive buildup and clean it if necessary.
4. Ground yourself by touching a metal object other than the printer. Grounding prevents
electrostatic discharge, which may damage your printer.
5. Clean the printhead area of all adhesive and label particles using a Cleaning Pen or a soft
cloth moistened with isopropyl alcohol.
6. Reload the supply roll and close the supply cover.
Cleaning the Platen, Liner Drive, and Pinch Rollers
Clean these rollers when you see significant adhesive build-up or when a label is wrapped
around them.
1. Turn off the printer, open the supply cover, and open the label deflector.
2. Remove the supplies.
3. Hold the printer upright and gently push down on the label deflector. It may be stiff.
4. Use a dry, soft-bristle brush, such as a toothbrush, to clean the rollers.
If the brush does not remove all adhesive, moisten a cotton swab with isopropyl alcohol
and run the cotton swab across the roller. Wait a few minutes for the printer to dry.
P i n c h R ol l er
L i n er Dr i ve R o l l er
P l a te n R o ll e r
5. Reload the supplies, close the label deflector and supply cover.
5-2 Operator's Handbook