Avery Dennison Sierra Sport4 9493 System Administrator Guide - Manual (Page 11)

Setting Up the Printer 2-3
Adjusting the Supply Position
Use this option to adjust how much of a label or tag feeds out of the printer.
The range is -10 to 99. The default is 00. You may need to adjust the supply in or out to allow
♦ tags and labels to be removed.
♦ die cut labels to be removed easily.
1. From the Printer Setup menu, select Supply Pos.
2. Press D or U to decrease or increase the amount of supply that feeds out of the printer in
one-step increments. Hold down the buttons to decrease or increase in five-step increments.
3 . When the setting you need is displayed, press e to save the setting or press X to cancel
without saving changes. You return to the Printer Setup menu.
Adjusting the Print Position
Use this option to adjust where data prints vertically on the supply.
The range is -99 to +99. The default is 0. Adjust the print if it is too close to the top or the
bottom of the supply, or overtypes a pre-printed area.
1. From the Printer menu, select Print Pos.
2. Press D or U to decrease or increase the setting in one-step increments. Hold down the
buttons to decrease or increase in five-step increments.
Decreasing the value moves the printed data toward the bottom of the supply (in the
feed direction), increasing the value moves the printed data toward the top of the supply
(opposite the feed direction).
3. When the setting you need is displayed, press e to save the setting or press X to cancel
without saving changes. You return to the Printer Setup menu.