Avery Dennison Sierra Sport2 9460 Programmer Manual - Manual (Page 150)

730 A memory allocation error occurred during initialization.
750 Printhead is overheated. Turn off the printer to let the printhead
cool. If the error persists, call Technical Support.
751 Printer did not sense a black mark when expected. The supply
may be jammed. For errors 751-753, check the
¨ supply tracking
¨ supply marks
¨ black mark sensor position
¨ supply roll for binding.
Press the left A button and try to continue printing. If the error
continues to appear, change the supply
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754 Printer has a ribbon problem. Check the ribbon for a jam or
remove any slack by turning the take-up reel clockwise. Load a
new ribbon.
755 Printhead is open. Close the printhead before continuing. If the
error persists, call Technical Support.
756 The printer is out of supplies. Load supplies.
757 Load supplies. The calibrated supply length differs by plus or
minus .25 inches from the format. Press F to print on the current
supply or load new supply and press A.
758 Check supply. Either the supply is not seen, or the on-demand
sensor is broken (purchase optional). Check for a label jam.
Clear the supply path or reload supplies. This error may occur if
you remove a label too quickly in on-demand mode. The printer
does not recalibrate after this error.
762 Low battery. Recharge the battery.
763 Waiting to dispense label. Press F.
8-18 Diagnostics and Errors