Avery Dennison Sierra Sport2 9460 Programmer Manual - Manual (Page 35)

Command Parameter
^CA
Cancels all the batches in the queue unless an error exists on the printer.
^CB
Cancels only the current batch being printed unless an error exists.
^DD or ^DCd Disables the MPCL data escape character (the tilde) and inhibits MPCL from acting on
ANY data escape sequence from the host. Sets the MPCL data escape character to the
ASCII value given by the d parameter. The value can be any ASCII character.
^EA
Aborts an error condition. This command is the same as pressing the left A button to
clear an error. May need to be sent multiple times. Use ^RB to reprint batch.
CAUTION: This command causes the current batch to stop and the condition that
caused the error to remain uncorrected.
^ED
Disable error reporting.
^EA
Enable error reporting. Sends an “E” plus the error number to the serial port, so a print
server can track errors. For example, error 704 is sent to the serial port as E704.
^ER Resets the error. This command is the same as pressing F to acknowledge an error.
Normal operation resumes.
^FD
Feeds a label when printer is idle. Simulates the operation of pressing F and
dispenses the next label if printer is in the on-demand mode.
Note: Printer ignores this command if printing.
^ID or ^ICd
Disables the Immediate Command feature by turning off the Immediate Command
escape character. Sets the Immediate Command escape character to the ASCII value
given by the d parameter. The value can be any ASCII character. Use ^IE to enable
immediate commands.
^MC
Returns the customer ID or RPQ version to the host. (00 to 99)
^MD
Returns the printhead dot density to the host. 00 = 203 dpi
^MF
Uploads the MIF file to the host.
^MI
Returns the customer ID or RPQ revision level to the host. (00 to 99)
^MM Returns the model number to the host. 22 = 9460
^MP Returns the prototype number to the host. (00 to 99)
^MR Returns the revision number to the host. (00 to 99)
^MS Returns the flash file system information.
^MV Returns the version number to the host. (00 to 99)
^PR Resets the printer. This command takes five seconds to complete and then the printer
is ready to receive data. It has the same effect as turning off and then turning on the
printer. Note: Command should be used only when the printer is not printing.
^RB Repeats the last printed batch, printing the same number of labels as specified in the
original batch. This command does not work if using batch separators.
Note:
Printer ignores this command if printing.
Configuring the Printer 2-17