Avery Dennison ALS 350 User Manual
Avery Dennison Equipment
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- 1 Please observe the following
- 2 Equipment description
- 3 Prior to operating
- 3.1 Insert the labelling material - ALS 350
- 3.2 Insert the labelling material - ALS 450
- 3.3 Mechanical settings
- 4 Operation
- 4.1 Activation and shut-down
- 4.2 Setting and monitoring
- 4.3 Product databanks
- 4.4 Settings in the extended menu
- 4.4.1 Overview
- 4.4.2 Activating an extended menu
- 4.4.3 Position of second label (POS2)
- 4.4.4 Position of third label (POS3)
- 4.4.5 Speed ratio (VERT)
- 4.4.6 Adjust the label stop sensor (CONT)
- 4.4.7 Label distance (LPIT)
- 4.4.8 Distance from the label stop sensor to the dispensing edge (E-SS)
- 4.4.9 Product length (PRDL)
- 4.4.10 Polarity of the product sensor (P_S_)
- 4.4.11 Polarity of the label stop sensor (S_S_)
- 4.4.12 Number of unlabelled products (MLAB)
- 4.4.13 Electronic transmission ratio of the RPM transmitter (EGRA)
- 4.4.14 Advance print start (PDT)
- 4.4.15 Printer dwell time (PDWT)
- 4.4.16 Tandem operation (TMOD)
- 4.4.17 Applicator type (APPL)
- 4.4.18 EP cylinder dwell time (APT1)
- 4.4.19 Blowing time (APT2)
- 4.4.20 Delay time (APT3)
- 4.4.21 Fine tuning of the dwell time (APT4)
- 4.4.22 Delete a product data bank (LOAD)
- 4.4.23 Create / save product data bank (SAVE)
- 4.4.24 Delete a product data bank (DEL)
- 4.5 Automatic dispensing speed (APSF)
- 4.6 Applicator (optional)
- 5 After operation
- 6 Operational malfunctions
- 7 Appendix