Avery Dennison Renegade 4 9490 Wall Chart - Manual

CHARGING THE BATTERY
1. Turn the printer off.
2. Remove the battery from the printer.
3. Plug the charger’s connector into the
battery socket. The charger’s LED
indicator is solid amber when the
charger is fully connected.
4. Plug the charger into a grounded
electrical outlet of the correct voltage:
✦ trickle charger takes 8 hours
✦ fast charger takes about 2 hours
5. Unplug the charger from the battery
when charging is complete.
CLEARING JAMS
The LED flashes amber and green when a
jam occurs.
1. Turn the printer off and open the printer
(see decal on the back of the printer).
2. Remove the label roll and any jammed
labels.
3. Clean the printer to remove build up
(see "Cleaning the Printer" below).
4. Reload the label roll. Close the printer
and turn it on.
®
R E N E G A D E
Refer to the Operator’s Handbook for more details on these procedures.
TC9490WC Rev. AA 12/99 ©1999 Monarch Marking Systems, Inc. All rights reserved.
Battery
Charger
Battery
Connector
Label
Roll