Loading labels, Loading for peel mode, Loading for non-peel mode – Avery Dennison Renegade 4 9490 Wall Chart User Manual
Page 3
Advertising
LOADING LABELS
1. Open the printer (see decal on the back
of the printer).
2. Insert the label roll into place between
the supply holders. The label roll should
unwind as shown. Make sure the labels
are free to unwind.
3. Load labels in peel or non-peel mode as
shown below.
Loading for Peel Mode
1. Feed the labels over the peel bar and
through the lower opening in the
supply guide.
2. Close the printer and turn it on.
Loading for Non-Peel Mode
1. Feed the labels through the upper
opening in the supply guide.
2. Close the printer and turn it on.
4 P r i n t e r
Supply
Holder
Lower
Opening
Supply
Guide
Upper
Opening
Advertising