Avery Dennison Full Size Sensor - Manual (Page 10)

Service Manual Full Size Sensor
11/07
Rev. 1.03 10
Now the other parts of the full size sensor can be mounted to the other axles – please
follow the shown sequence
outer
media guiding
lower part of the sensor
inner
media guiding
Then insert the upper – rear axle into the outer side plate – the upper part of the
full size sensor (rear hole) has to slide on the axle
The two lower axles slip into the holes of the inner side plate and have to be adjusted
in a way that 1,8 mm (+/- 0,1 mm) of the axles are looking out of the inner side plate
Fix the axles by use of the hexagonal screws.
1,8 mm