Aviosys 8840 Installation - Manual (Page 2)

2
Software Installation
1. Before install 8840, Please make sure that your PC had install .NET . Or
please go to here to download before install USB Power 8840 . :
http://www.microsoft.com/en-us/download/details.aspx?id=21
2. Please put the CD in your CD ROM and it will execute AUTORUN. file or you
can open by Windows . Please use web browser “ IE “ to open the CD. Then
go to Manual  USB Series  USB Power 8840 to download the driver
“ USB Net Power Driver ” and the software “USB Power 8840.exe “ into your
hard disk .
3. Connect the 8840 power and the USB port of 8840 power to PC . PC will show
up “ Detect New Hardware” , then select the 8840 driver and install . After
install the driver, you can check in devic manager to make sure the driver
install successfully :
Control Panel  System  Device manager  Ports(COM& LPT)  Aviosys Port (COM X)
4.) After confirm the 8840 had shown in Device Manager , please execute the software
“USB Power 8840.exe “ and you will get as following :
Thank you use USB Power 8840. You can refer the details in manual of CD.