Baby Lock Grace (Previous Model) (BL40A) Quick Reference Guide - Manual (Page 5)

Winding the Bobbin
3
7. While using your left hand to hold the thread that was passed through the bobbin-winding
thread guide, use your right hand to wind the end of the thread clockwise around the bobbin
five or six times.
8. Pass the end of the thread through the slit in the bobbin winder seat, and then pull the thread
to the right to cut it. The thread is cut to a suitable length.
9. Press start/stop button once. The bobbin starts spinning and the thread is wound around the
bobbin. Slide the sewing speed controller to the right to increase the speed, if desired.
10. When the bobbin winding becomes slow, press start/stop button once to stop the machine.
11. Cut the thread, slide the bobbin winder shaft to the left, and then remove the bobbin from the
shaft.
NOTE: When the sewing machine is started or the handwheel is turned after winding the bobbin, the
machine will make a clicking sound; this is not a malfunction. Sewing is not possible while the bobbin
winder shaft is moved to the right.
1 Slit in bobbin seat (with built-in cutter)
1 Start/Stop button
2 Sewing speed controller
2