Baby Lock Ovation (BLES8) Instruction and Reference Guide - Manual (Page 87)

The fixed blade is made of a special long lasting steel and does not require frequent replacement.
If necessary, contact your nearest retailer for replacement of the blade.
The upper cutting blade is made of a softer steel material and will require replacement. A spare
blade is provided with the machine for replacement if necessary. The spare upper cutting blade is
located in the accessory compartment & thread stand.
If for some reason your machine does not cut or perform as it should be, please take your machine
to your nearest Baby Lock retailer. It is possible that the result of poor cutting may indicate other
problems.
M
A
I
N
T
E
N
A
N
C
E
85
Replacing Cutting Blades
A
TO REPLACE UPPER CUTTING BLADE proceed as follow :
1. For safety reasons, unplug main power cord.
2. Open front cover and cutting blade cover. (fig. A)
3. Remove screw and upper blade. (fig. B)
4. Insert new upper blade into blade slot.
5. Insert screw and place upper blade to its highest position.
6. Hold upper blade in place and tighten screw.
7. Check and make sure that the upper section of cutting area of
blade is set 1mm below the fixed blade when upper blade is in
its lowest position. (fig.C)
8. Close cutting blade cover and front cover.
Replacing LED Lighting
Your Baby Lock Ovation is equipped with a long-life LED lighting system, which is not necessary
to change bulbs.
In case of replacing LED unit, please contact your authorized Baby Lock retailer.
B
C
1 mm