Baby Lock Symphony (BLSY) Instruction and Reference Guide Addendum - Manual (Page 12)

10
h
Install the needle plate cover.
For details on installing the needle plate cover,
refer to “Cleaning the Race” in the Instruction
and Reference Guide.
a Needle plate cover
i
Install the flat bed attachment.
j
Insert the thread tail from the spool of thread
through the hole in the bobbin from the inside
to the outside. Hold the thread tail while
winding the thread around the bobbin by
hand. After winding the bobbin so it is filled
as shown below (about 80%), cut the thread.
k
Using scissors carefully trim the thread tail as
close to the bobbin as possible.
a Beginning of wound thread
l
Install the bobbin wound with thread.
Whether or not tension should be applied to the
bobbin thread depends on the type of thread
used.
Note
• The bobbin case (gray) cannot be used for sewing in
any way other than bobbin work. After sewing
bobbin work, refer back to the steps in "Preparing
the Bobbin Thread" for removing and cleaning the
bobbin case (gray), and then reinstall the standard
bobbin case (black).
CAUTION
• Be sure to use the bobbin case (gray) when creating
bobbin work. Using any other bobbin case may
result in the thread becoming tangled or damage to
the machine.
• Make sure that the bobbin case is correctly
installed. If the bobbin case is incorrectly installed,
the thread may become tangled or the machine may
be damaged.
CAUTION
• When creating bobbin work, use the cord guide
bobbin cover (for bobbin work and attaching
cords), otherwise the thread may become tangled
or the needle may break.
CAUTION
• Be sure to use the included bobbin or one designed
specifically for this machine (Class 15). Using any
other bobbin may result in damage or injuries.
Actual size
11.5 mm
(approx.
7/16 inch)
This model Other models
Note
• Slowly and evenly wind the thread around the
bobbin.
• For best results, wind the bobbin so the thread is not
twisted.
CAUTION
• If thread extends beyond the top of the bobbin too
much, the thread may become tangled or the
needle may break.
Memo
If inserting thread tail through bobbin hole is difficult
bobbin can be wound by holding tail and wrapping
thread around inside base. Then carefully trim thread
tail so it does not extend from the side of the bobbin.