Baumatic B25SE - Manual (Page 33)

32
o
Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler). If this is not feasible, then you
should install an insulation plate between the appliance and the
adjacent heat source.
o
You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
o
Place the appliance flatly and firmly on a solid base. The
appliance is fitted with adjustable feet on the front side, which
can be used to level the appliance.
o
The rear side of the appliance is fitted with wheels which
facilitate the positioning of the appliance into its final location.
o
Anything positioned above the appliance must be at least 30 cm
away to allow sufficient cooling of the condenser. You must allow
a 5 cm gap either side of the appliance and a 10 cm gap to the
rear.
o
If you are placing another cooling appliance next door to this
product, then there must be a gap of at least 5 cm between the
appliances. This will help to prevent condensation from forming.
o
Be sure to leave enough space for the opening of the door, to
avoid damage to the appliance or personal injury.
Installation preparation
IMPORTANT: A minimum of two people should
complete all of the installation steps given in this
manual.
o
Check that the appliance will easily pass through all doorways
en-route to its final position.
o
Appliance dimensions: 1760 mm (h) x 902 mm (w) x 750 mm
(d) (including door handles).
o
If your appliance will not fit through a doorway, then it is
possible to remove the fridge and freezer doors by following the
process on the following pages.