Beisler 1360-4 - Manual (Page 91)

D-22
Programming Instructions Automatic Multi-Head Serging Machine 1365-4 Beisler GmbH
D.3
Programming
2. Determine the position of the seam in the sewing sequence. Position
the cursor on the number of the seam after which the disabled seam
is to be sewn again:
• Press the &or / key
3. Enable seam:
• Enter the seam number using the numeric keypad
4. Confirm change:
• Press the ( key
The display shows the seam number in the seam sequence.
Preseams
The A/C machine can be set for processing the preseams (waist seam,
inseam and hem seam). This settings are effective only if the preseams
are enabled.
Selecting the short seam parameter list:
"
• Press the c key
1. HEM SEAM SPEED
Sewing speed
SEAM TOP FEEDING
Basic setting for fullness
SEAM DIFFERENTIAL
Basic setting for fullness
PULLER ON/OFF
Switch puller on/off
01 Enable function
00 Disable function
2. WAIST SEAM SPEED
Sewing speed
HEM TOP FEEDING
Basic setting for fullness
HEM DIFFERENTIAL
Basic setting for fullness
PULLER ON/OFF
Switch puller on/off
01 Enable function
00 Disable function