Beisler 739-23-1 Manual - Manual (Page 11)

2.3 Inserting of needle thread
Caution: risk of injury!
Switch off main switch.
Never insert the needle thread while the main switch is on.
To insert the needle thread, please proceed as shown in the above
figures and in sequence of the numbers.
– Place yarn reel onto the yarn stand.
– Insert thread from the reel through hole 1 of the reeling bracket.
– Insert thread through guide 2.
– Insert thread through thread regulator 3.
– Insert thread in clockwise direction into the thread tensioner 4, over
the thread tensining spring 5 and below guide 6.
– Pull thread through guide 7 and thread regulator 3 upwards to the
thread lever.
– Insert thread trough the hole in thread lever 8 and again through
guide 7.
– Insert thread through the thread monitor 9 and guide 10.
– Insert thread through the belt wheel 11 to the needle.
– Insert thread in needle 12.
2.4 Needle thread monitor
The needle thread is monitored by means of switch 9.
If the thread is broken or the end of the thread is reached, the switch is
not activated.
Caution: risk of injury!
Switch off main switch.
Do never insert the needle thread while the main switch is on.
– Insert needle thread.
– Switch on main switch.
– Start new sewing process
1-11