Beisler 739-23-1 Manual - Manual (Page 20)

4. Switching on of sewing machine and infeed of material clamps
4.1 Switching on of sewing machine
– Switch on main switch 1.
The control system is initialised.
The start message is displayed.
Prior to working with the sewing machine, the sewing axes must be
positined in the reference position.
CAUTION!
The reference run must be carried out by the operating staff.
CAUTION! Risk of breakage!
The material clamp may not be inserted during the reference run.
The following message indicates that a reference run is required.
To remove a material clamp that is still inserted in the machine use the
arrow keys “
“ and ” “ to manually move and remove it.
– Press “OK” key.
The reference run is carried out.
After the reference run has been completed successfully, the display
changes to:
After 0.5 seconds, the machine program changes to operating mode.
1-20
1