Directed Electronics 1.3X - Manual (Page 30)

30 © 2008 Directed Electronics. All rights reserved.
➤
Valet take-over
The Valet take-over feature allows the vehicle to remain running after the key has
been removed from the ignition. This feature is useful for occasions when you
want to exit and lock the vehicle for short periods of time, but would like to leave
the motor running and the climate controls on.
To perform Valet take-over:
Before turning Off the engine, press and release the 1. A U X button on the
transmitter within 3 seconds.
The parking lights flash one time to confirm that valet -take-over has been
initiated Then wait a few seconds.
Turn the ignition key to the Off position (The engine remains running). 2.
Exit the vehicle and lock the system with the remote. 3.
The engine runs until the pre-programmed time elapses or a shut-down
input is received.
Note: To enable valet take-over with a manual transmission, open the door when
going into MTS mode. The parking lights flash one-time to confirm entry into
valet takeover. After you exit the vehicle you can lock the system with the remote
and the car remains running. If the vehicle shuts down when locking, then the
unit did not enter the valet take-over mode.