Beurer FCE 90 - Manual (Page 13)

13
4.1 Care treatment function (mornings):
Preheating phase
30 seconds
heat
2 min
Precooling phase
30 seconds
cool
2 min
• Apply the Advanced Hydro Lift Cream to the area of your face that you wish to treat.
• Press the ON/OFF button on the device.
• Press the heat button first and then press the negative ions button . The device is now in the pre-
heating phase for 30 seconds. “WAITING” is shown in the display. As soon as the “WAITING” display
turns off, the device is ready to use.
• Now use the treatment head to gently massage your face in circular motions.
• After two minutes of treatment, press the cool button and the negative ions button . The device is
now in the precooling phase for 30 seconds. “WAITING” is shown in the display. As soon as the “WAI-
TING” display turns off, the device is ready to use. Continue with the treatment for another two minutes.
• To switch the device off again, press the ON/OFF button .
4.2 Combination of cleansing and care treatment functions (evenings):
Cleansing:
Preheating phase
30 seconds
heat heat
3 min 1 min
• Apply the cleansing milk to your face.
• Press the ON/OFF button on the device.
• Press the heat button first
and then press the negative ions button . The device is now in the pre-
heating phase for 30 seconds. “WAITING” is shown in the display. As soon as the “WAITING” display
turns off, the device is ready to use.
• Now use the treatment head to gently massage your face in circular motions.
• After three minutes, press the positive ions button and continue the treatment for another minute. Af-
ter the cleansing treatment, wash your face with lukewarm water.
Care:
After you have completed the cleansing treatment function, continue with the care treatment as follows:
Preheating phase
30 seconds
heat
1 min
Precooling phase
30 seconds
cool
1 min
Repeat the process
once from the beginning
• Clean the treatment head with a lint-free cloth until there is no trace of cleansing milk left on the head.
• Apply the Advanced Hydro Lift Cream to the area of your face that you wish to treat.
• Press the heat button first and then press the negative ions button . The device is now in the pre-
heating phase for 30 seconds. “WAITING” is shown in the display. As soon as the “WAITING” display
turns off, the device is ready to use.
• Now use the treatment head to gently massage your face in circular motions.
• After one minute of treatment, press the cool button . The device is now in the precooling phase for
30 seconds. “WAITING” is shown in the display. As soon as the “WAITING” display turns off, the device
is ready to use. Continue with the treatment for another minute.
• Repeat this heat and cool treatment as described above for one minute each. If necessary, apply a little
more Advanced Hydro Lift Cream.
• To switch the device off again, press the ON/OFF button .