Beurer HLE 30 - Manual (Page 13)

13
• Do not use the device on irritated skin, varicose veins, rashes, spots, (hairy) birthmarks
or wounds without consulting a doctor beforehand. The same applies to patients with
weakened immune systems, diabetes, haemophilia and immune insufficiency.
• If the charger indicator lamps flash slowly this means that the battery is charging. Once
the display is permanently illuminated, the device is fully charged.
Then you can begin using the device on battery power. Mains operation is not possible.
• If the charger indicator lamps flash rapidly during battery operation, the battery is empty.
Charge the device by placing it on the station or connecting it to the mains adapter.
• One charge is sufficient for approx. 40 minutes of wireless operation.
Note
• Batteries do not have their full load capacity from the beginning. In order to achieve the full
load capacity of the batteries, they should be fully charged, completely discharged and
then fully charged once more prior to initial operation of the device. This recharge/discharge
cycle should be repeated as often as possible to extend the service life of the batteries.
• The lady shaver can be used in the shower or bath and it can be cleaned under running
water.
• When used on dry skin, the skin must be completely dry and free from grease.
• When used on wet skin, it is important that the skin is sufficiently damp so that the device
can glide optimally over the skin. Shower gel or soap facilitates the shaving process.
• Do not use creams/lotions containing alcohol before or after using the shaver.
• In order to avoid irritation, do not press the shaver head too firmly onto the skin.
• Thoroughly clean the shaver head before shaving. This reduces the risk of infection as far as
is possible.
• Press the on/off button to switch on the device.
• The LED light ensures optimal lighting conditions so that you can see and remove the finest
hairs.
• Hold the skin taught with your free hand, to raise the hair.
• Use the device slowly, steadily and without pressure with the illuminated side against the di-
rection of hair growth. As hair doesn‘t always grow in one direction, it can be useful to move
the device in various directions over the skin to achieve an optimal result.
Using the spacer combs
Using the spacer combs, you can cut your hair to two different lengths:
• Small spacer comb 4mm
• Large spacer comb 8mm
• Position the comb you wish to use on the shaver head such that the teeth of the comb face
outward on the illuminated side.
• Switch the device on and always move the device against the direction of hair growth.
• Ensure that the comb surface always remains in contact with the skin.